Kicker Amphitheater K3 Owner's Manual

Contents

Kicker Amphitheater K3 Owner's Manual Manual pdf 6 page image

6 ENGLISHIMPORTANT SAFETY INSTRUCTIONSTROUBLESHOOTINGRead and follow all the instructions listed in this manual. Keep these instructions and heed all warnings. Follow all safety andprocedural recommendations to prevent damage to your self, your KICKER product, or your portable media device.The Amphitheater K3 should not be used near water or in an environment where exposure to liquids is possible. Thisincludes but is not exclusive to areas where splashing, dripping, leaks, spills, and exposure to rain can occur. Liquidcontainers should not be placed on or near the Amphitheater K3. The Amphitheater K3 should not be cleaned with liquidcleaners. Use only a dry cloth to clean the Amphitheater K3.Only use the Amphitheater K3 in areas with adequate open ventilation allowing at least 4” of space on all sides of theAmphitheater K3. Do not set the Amphitheater K3 on any surface or cover the Amphitheater K3 with any object that couldimpede the airflow to and from the Amphitheater K3. The Amphitheater K3 should not be placed near any source of heat.The battery pack or batteries installed shall not be exposed to excessive heat. This includes but is not limited to stoves,radiators, heating elements, electronic heat sources, and areas where excessive solar heat can be generated. Do not placethe Amphitheater K3 near any flame or place any fl ammable objects near the device.The power outlet used to provide power to the Amphitheater K3 should be accessible at all times. The power cordshould be situated in a way that protects it from being pinched, walked on, tripped over, or accidentally pulled from theelectrical outlet or the electrical input on the Amphitheater K3. Where the MAIN plug or an appliance coupler is usedas the disconnect device, the disconnect device shall remain readily operable. Do not run the cable through doorwaysor underneath objects that could damage the wire or tear the insulating material surrounding the wire. Only use themanufacturer supplied power supply with the Amphitheater K3. We recommend using a surge protector/power conditionerand unplugging the Amphitheater K3 during any electrical storms or situations that could cause voltage fluctuations in theelectrical system.DISCLAIMER: Bluetooth wireless audio compatible with most Bluetooth enabled phones, tablets and computersFactory Reset: Press and hold the | AUX button while turning the Powerswitch on.Speaker will not turn on:• On back of the system, make sure the power switch has been turned on.• Make sure that the power cord has been plugged directly into a wall outletand that the green LED on the power supply block is ON.Bluetooth device will not connect• Make sure the system has been set to Bluetooth mode(Blue status light),and that Bluetooth is enabled on your device.• Make sure your Bluetooth device is within 30ft of the system.• It is possible that another device is currently connected. Press and hold the| AUX button on the system to enter pairing mode (status light flashes blue)and pair your device again.• Perform factory reset and pair your device again.No Sound from Bluetooth device• Make sure device is connected to dock and audio is playing.• Make sure volume is turned up on device and on the speaker.Red Light• Unplug power for 10 minutes.• If red light continues, call KICKER Customer Service at (405) 624-8510.iK3BT User Manual Rev 9.indd 6iK3BT User Manual Rev 9.indd 6 11/25/2013 9:49:34 AM11/25/2013 9:49:34 AM