L-3 Communications Targa DTU40SA-50A-2 Technical Reference And Installation Manual
                                                        | |
Contents
| 
Targa Systems DivisionS4 Ethernet NAS DTS Installation Guide 32003272-1 Rev 54.4 DTU Configuration PageDisplays Targa DTU identificationdata and provides access to theDTU features configurationparameters.DTU Identification:Model#: Targa DTU Model#Serial#: DTU serialnumberFirmware: DTU firmwareversion and partnumberDTU FeaturesErase Input / Erase Algorithm:The Targa DTU supports aremote sourced Erase inputsignal used to activate a userspecified DTD Security Erasealgorithm. Refer to Appendix B for details on the supported Sanitize / SecureErase algorithms.If the Erase input is disabled, the Erase Algorithm entry is not applicable.Factory default is disabled.Erase Input Signal: (Secure_Erase- refer to 2.6.3 & 3.7)Active low input signal. Signal must transition from Off state (logic high) to Onstate (logic low) and be logic low for a minimum of 300msec for DTU toactivate erase. If the signal is detected as logic low at power up or at doorclosure the signal is disqualified until it returns to the logic high state (for aminimum 300msec). If the Erase Input feature is disabled the signal is notmonitored.Refer to the FTP Site command “dtdsanitize” for details on the ethernetcommanded DTD Secure Erase.Enable Temp Alerts: Enabled DisabledThe DTU is equipped with an on-board temperature sensor that can be usedto monitor the internal temperature. The temperature monitoring process canalso, when enabled, issue an alert at a user specified temperature. Refer tothe FTP Site command section for details on how to read unit temperatureand detect a temperature alert.Factory default is disabled.Temperature Alert at: Default: 90ºC Input range: 80ºC to 100ºCTemperature Alert value is used only when Temp Alert is enabled15 |
manualsdatabase
Your AI-powered manual search engine