L-Acoustics K2 WST Rigging Manual

Also see for K2 WST: User manual

L-Acoustics K2 WST Rigging Manual Manual pdf 18 page image

K2 WST® enclosureRIGGING MANUALVERSION 3.0K2_RM_EN_3.0 w w w . l - a c o u s t i c s . c o m 1 8 / 764 SYSTEM SETUP4.1 Ground-stackingFinal checkAfter the setup, always verify no yellow labels are visible on the front and on both sides of the array.K2 enclosures on K2-CHARIOT and K2-JACK Place a block of four K2 enclosures at the final position.If a block is not already built, refer to PROCEDURE A. Preset the inter-enclosure angles.Refer to PROCEDURE B. Attach the K2-JACK stabilizers to the K2-CHARIOT.Refer to PROCEDURE C. If needed, add one or two K2 enclosures to the stack.Refer to PROCEDURE A. Preset the inter-enclosure angles for the additional enclosures.Refer to PROCEDURE B. Push the topmost enclosure forward until all the automatic locks are inplace and verify that there is no yellow label visible. If necessary, change the position of the K2-CHARIOT rear rigging arm.Refer to PROCEDURE D. If necessary, fine-tune the site angle of the stack by adjusting the heightof the stabilizers feet.Refer to PROCEDURE E.K2 enclosures on K1-SB Stack as many K1-SB enclosures as necessary.Refer to the K1 rigging manual to set up the K1-SB part of the array. Position and attach a K2-BUMP on the K1-SB stackRefer to PROCEDURE L. Position and attach an upside down K2 on the K2-BUMP and add asmany K2 enclosures on top of the first one.Refer to PROCEDURE C.