L.B. White GUARDIAN AB250 Owner's Manual And Instructions

Also see for GUARDIAN AB250: Installation and service guide Installation and service guide Installation instructions Owner's manual and instructions

Contents

L.B. White GUARDIAN AB250 Owner's Manual And Instructions Manual pdf 10 page image

1. To CConnect tthe SSeries TTap PPlug TThermostat KKit:a. Connect the power cord of the heater to thefemale side of the plug on the end of thethermostat cord.b. Plug the male side of the series tap plug on thethermostat cord into a three-wire (grounded)electrical outlet within the building.2. To CConnect tthe DDirect WWired TThermostat KKit tto ttheControl BBox oon tthe HHeater:a. The installation and wiring of a thermostat mustbe done by an electrician or someone properlyqualified.b. The thermostat may use 18 gauge, 3 wire cord tohandle the voltage being supplied to thethermostat.c. Follow all instructions provided with thethermostat kit.d. The heater must be tested for proper operationafter the thermostat has been connected.WARNINGElectrical SShock HHazard■ Disconnect the electrical supply before connecting thethermostat to the heater.■ Failure to follow this warning can result in electricalshock, leading to personal injury or death.10THERMOSTAT INSTALLATIONMANUAL SHUT-OFF VALVE, HOSEAND REGULATOR ASSEMBLYREGULATORNIPPLEVALVE, MANUALSHUT-OFFGAS HOSEADAPTERSEDIMENT TRAPTO CONTROLVALVE INLETREGULATOR VENTGAS FLOW1. Always use approved pipe thread compound suitablefor use with L.P. gas or natural gas on the threadedconnections.2. Assemble the components together according to thefigure. This view is to show general assembly of thecomponents only. The regulator must always bemounted so its vent, regardless of location on theregulator, is always pointed downward.3. Tighten all connections securely.FIG. 5