Figure 3.2 Component IdentificationInstallation and Assembly InstructionsASSEMBLYWARNINGFire or explosion hazard!Do not operate heater without support frame fullyassembled to tank.Front HandleRear HandleAxleWheel Support FrameTOOLS REQUIREDCP045CK/CP075CKCP125DK/CP175DK/CP210DK- Medium Phillips screwdriver.- M5 open, or adjustable wrench.1. Slide threaded axle through the rear section of the wheel support frame.NOTE When installing wheels, tube valve should face out from support frame (Figure 5).2. Slide one axle bushing on to each side of the axle. Slide one wheel on to each side of the axle.3. Attach one cap nut on to each side of the threaded axle and tighten well.4. Place heater on wheel support frame. Make sure the air inlet end (rear) of heater is over wheels. Align the holes on fueltank flange. Insert screws through handles (front and rear), fuel tank flange, and wheel support frame as shown inFigure 5 and attach nut finger tight after each screw is inserted.5. After all screws are inserted, tighten nuts firmly.6. Align the hole on the handle (front and rear) with the mounting hole on the cord wrap.7. Insert screws through cord wrap, handles as shown in Figure 5 and attach nut finger tight after each screw is inserted.8. After all screws are inserted, tighten nuts firmly.USE CAUTION WHEN INFLATING TIRES:- Do NOT over inflate tire. Maximum air pressure is 36 PSI.- Over inflation may lead to serious injury- NEVER fill tires using an air compressor. A manual pump is recommendedWheel Support FrameWheelsFront-HandleRear-HandleAxleYesNoNoNoNoNoYesYesYes YesYes Yes YesYesYesYes YesYes YesYes Yes YesYes Yes YesYes YesYes No No NoYesCord WrapHHandleardware KitModel CP045CK/CP075CK CP125DK CP175DK CP210DKCP175DK CP210DKCap Nut S Cap Nuts LFlange Screws NutsBushingsWheelsCP125DK / /Cord WrapsScrewsFigure – Component IdentificationHandle Hardware Kit Cord WrapsCCPP004455CKK // CCPP007755CKK MMooddeellss HandleFFiigguurree 44 – Handle and Cord Wrap Installation CP045CK and CP075CKFront GuardScrewSide CoverSupporterCord WrapWedgedPortionSlit HoleScrew3.1- Medium Phillips screwdriver.1. Lift front guard for arrow direction and make sure that guard’s wedged portion fits into the slit hole on the upper housing.2. Align the holes in upper housing with two mounting holes on the handle as shown in Figure 4.3. Secure handle with screws provided.4. Insert cord wrap into the rectangle holes on the supporter and align the hole on the cord wrap with the mounting hole on the sidecovers shown in Figure 4.5. Secure cord wrap with screws provided.9