L3 comminications ProTec Installation And Operation Manual
                                                                      | |
Contents
| 
Marine SystemsAviation RecordersRev. 02 Page 2--17July 29/03Automatic Identification System(4) Enter the new password in both fields, and press the ENT key. This will savethe new password.(5) Press the ESC key to go back to the System Configuration screen.S yP aV es sr iP u ts t e mw df y::N e wP a sP w dsiw o r dn B oC h at h Fn g ei e l d sFigure 2--12. Password Change Screen2.1.4.7 System Alert ScreenThis screen will appear when a system alert is received. Press the ENT key to ac-knowledge the alert.* * ** * *N o v* * *S y s tA l a ra l i dP r e se m Am 0C O Gs E Nl3Te r t0 A ci n f ot oP a g et i v er m a tA C K* * ** * *i o n* * *Figure 2--13. System Alert Screen2.1.4.8 Alarm StatusThe ProTec AIS unit does not support a “General Failure” alarm since all detectedfailures are reported with an explicit discrete alarm message.To review Safety Text Messages that have been received, perform thefollowing:(1) Press the FNC key.(2) Press the Setup key. The System Configuration screen will appear. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine