ESI-2000Pilot’s Guide3-2operating InstructionsNoTEManually shutting down the ESI-2000 conserves batteryenergy and is recommended in hot climate conditions.Depending on the aircraft, remove power to the ESI-2000 using either theavionics master switch, the battery switch, or dedicated ESI-2000 Powerswitch (as applicable).The ESI-2000 automatically switches over to battery power. A countdowntimer and a flashing message is displayed on the screen as shown below:The ESI-2000 automatically shuts down in 5 minutes if no key (button) ispressed. The battery continues to discharge for the entire 5 minutes. Whentime is less than 30 seconds, the messages change as shown below:At the end of the 5 minutes the timer and “press any key” message areremoved and the following message is shown as the ESI-2000 enters itsshutdown mode:The ESI-2000 can be manually shutdown (only when in discharge mode)using the following procedure:Press any key (button) as stated by the message.Press the M (Menu) button repeatedly until the Shutdown menu isshown. See Figure 3-1.Press and hold the + (Hold) button until the ‘SHUTTING DN’message is shown in the upper left corner of the screen.1.2.3.Figure 3-1: Shutdown MenuPowER off (Refer to Figure 3-1)Shut Dn 5.0mPRESS ANY kEY FOR BATTERY POWERShut Dn 29sPRESS ANY kEY FOR BATTERY POWERSHUTTING DN