LATICRETE STRATA_HEAT 0802-0067-2 Installation Manual

LATICRETE STRATA_HEAT 0802-0067-2 Installation Manual Manual pdf 17 page image

17INSTALLING THE FLOOR SENSORThe floor sensor is used for temperature regulation of the floor surface. Theend of the probe wire contains a capped sensor that should be centeredbetween two heating cables at least 12" (305 mm) into the heated area.The sensor wire MUST NOT touch or cross over the STRATA_HEAT™ Wires.Depending on the requirements of the tiler, it may be necessary to chisel outshort channels in the subfloor to minimize the increased height presentedby the floor probe. Before chiseling the area, ensure that the STRATA_HEATWire, unheated lead and floor probe are protected to avoid damage duringchiseling. Place the floor probe into the channels and secure with fixing tape.NOTE: Do NOT run the cold lead wires and the floor sensor in the same conduit.Installing the STRATA_HEAT ™ ThermostatInstructions for the fitting of the STRATA_HEAT Thermostat can be found inside the thermostat box. Each cable has one unheated lead.Please review the information on pages 10 through 13 before proceeding.The protective ground wire leading from the unheated lead should be connected to the ground leading from the power supply.IMPORTANT! Test the STRATA_HEAT™ WireBefore installing the final floor finish ensure that the STRATA_HEAT™ Wireis working properly using the method described on page 14.Test the probe wire:Temperature sensor wire must be verified before and after installation.For probe resistances, refer to the STRATA_HEAT Thermostat instructions.

/ 28

Related manuals for LATICRETE STRATA_HEAT 0802-0017-2

LATICRETE STRATA_HEAT 120V Quick Start Manual

manualsdatabase

Your AI-powered manual search engine