LAVAMAT 52810 User Information

LAVAMAT 52810 User Information Manual pdf 15 page image

15Interrupting a programme/adding washingInterrupting a programme• A washing programme can be interrupted at any time by pressing theSTART/PAUSE button. It is then re-started by pressing the START/PAUSE button again.• To stop the washing machine before the programme has ended, turnthe programme knob to OFF. Important! Be careful if there is waterin the appliance!Adding washingIt is possible to add washing, as long as the DOOR light is not lit.1. Press the START/PAUSE button. The door can be opened.2. Shut door and press the START/PAUSE button again. The programmecontinues.Washing cycle complete/removing the washingAt the end of the programme, END lights up on the programmeprogress display. The door can be opened as soon as the DOOR lightgoes off and the END light has come on.1. Open the door and remove the washing.2. Turn the programme knob to OFF.3. Close the water tap.4. After the wash, pull out the detergent dispenser drawer slightly to al-low it to dry. Leave the door slightly open to air the inside of the wash-ing machine.If RINSE HOLD was selected:After a rinse hold, DOOR and END light up on the programme progressdisplay.The water must first be drained:– Either turn the programme knob to OFF, then to DRAIN and press theSTART/PAUSE button (the water is drained without spinning),– or turn the programme knob to OFF and then to SPIN. Dependingupon the type of washing, reduce the spin speed if necessary andpress the START/PAUSE button (the water is drained and the washingspun).