LAZBOY PowerReclineXR+ Series Operating Instructions Manual

Also see for PowerReclineXR+ Series: Operating instructions

Contents

operating instructions

LAZBOY PowerReclineXR+ Series Operating Instructions Manual Manual pdf 5 page image

98PowerReclineXR®+Operating InstructionsBattery Backup Assembly InstructionsNOTICE:The battery backup is located in the power transformer and uses two 9-volt alkalinebatteries (not included).1. Unplug the 120 volt power cord from the electrical outlet, and disconnect the powertransformer connector from the power supply connector.2. The battery compartment is located in the bottom of the power transformer. Slide the batterycover over to access the battery compartment.3. Snap the connection caps on the battery terminals. Place the batteries in the power transformer.4. Slide the battery cover over the batteries.5. Proceed to the Operating Instructions.PowerTransformer(2) 9-VoltAlkaline BatteriesPowerReclineXR®+ Transformer Specifications:Input: 100V-240V AC 50/60Hz 86VAOutput: 29V DC 2.5ABatteryCoverReplace the power transformer batteries every six months andafter each power failure use. Under normal conditions, the batterybackup will operate the chair two times, but this performancecannot be guaranteed.– To reduce the risk of electric shock, seriousinjury or death:• Plug directly into a wall outlet. Do not use an extension cord, adapter or surge protector.DANGER– To reduce the risk of serious injury:• Sit down in the unit slowly. To avoid tip over, do not throw your weight against the backof the unit. Move the unit into or out of the reclining position slowly, making sure thatno children or pets are in close proximity.• The PowerReclineXR + units are intended for a single occupant not exceeding 300 poundsper seat. Do not operate an individual seat with more than one occupant in or on anypart of the individual seat.• To safely exit the unit and prevent a tripping hazard, bring the back uprightand close the legrest.• The operating cycle of PowerReclineXR ® + units is 1 minute on and 9 minutes off.WARNINGPlug the power cord directly into a wall outlet. Make sure there is enough slack in the cord runningfrom the chair to the outlet to allow for rocking and reclining. Never stretch or strain a cord.The PowerReclineXR® + offers three reclining options along with several adjustmentpositions for the headrest and lumbar for the ultimate in customized comfort:• Only recline the back. When the back is reclined, the chair can be rocked.• Only extend the legrest. When the legrest is extended, the chair body tilts backward.• Operate both the back recline and legrest extension simultaneously.• Position the headrest forward when reclined, stopping in any one of the various angles of support.• Increase the intensity of the lumbar support stopping in any one of the various levelsfor optimal lower lumbar support.To recline, press and hold down one of the three reclining option buttons on the right side of thehand wand. Release the button when you have reached a comfortable position.To return to the upright position, press and hold down one of the three return buttons on the leftside of the hand wand. Release the button when you have reached a comfortable position, orwhen the back is fully upright and the legrest is fully closed.To rotate the headrest forward, press and hold down the button on the right. To return theheadrest to the upright position, press and hold down the button on the left. Release the buttonwhen you have reached a comfortable position, or when the headrest is fully retracted.To increase lumbar intensity, press and hold down the button on the right. To decrease thelumbar intensity, press and hold down the button on the left. Release the button when you havereached a comfortable level, or when the lumbar is fully retracted.The function of each hand wand button is explained in greater detail on the following page.We recommend that you unplug the power transformer if you will be away from your residencefor an extended period of time.