LED Strip Studio LED Ethernet Controller 3 User Manual
Also see for LEC3: Manual
                                          | |
Contents
| 
FRONT CONNECTORSLEC3 front connectorsEthernet To control Ethernet board using LSS software you have toconnect your PC with Ethernet board using Ethernet cable.MMX OUT - Distributor output (MMXsignal)Output to following distributor. You can use more distributorsfrom one Ethernet board - you’ll get more LED-strip outputs.Status Three LEDs which show device status:➢ Green – power is on➢ Yellow – DMX or ArtNet is present (fast blink for DMX,slow blink for ArtNet)➢ Red – if on, LSS software is connected to the deviceover EthernetButtons Allows you to select file to play in auto play mode and also torun test patterns (in case the SD card is not inserted).IP/DMX Add. DIP switch allows you to set IP and DMX address. In auto-playmode can be used to set animation to play.SD-card FAT32 micro SD-card for storing LED videos/animations. Youcan trigger them using DMX, ArtNet or use them in auto playmode.DMX In/Out You can use DMX In/Out to control LEC3 or LSS software. DMXout can work in through or output mode (it’s a bit moreadvanced comparing to standard DMX).DMX LED Indicates, whether the DMX is in though mode (typically in DMXcontrol mode). |
Related manuals for LED Strip Studio LEC3
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine