LENCO LS-480WD User Manual

Also see for LS-480: User manual

- 8 -Note:• If the Phono/Line switch is set at LINE position but RCA jacks connected to the stereo system’s phono input, thesound might be distorted due to input overload and could damage your stereo system.• If the Phono/Line switch is set at PHONO position but RCA jacks connected to the stereo system’s line input,the volume will be very low due to lacking signal pre-amplification.RCA Jack is not designed to be connected directly to the passive/unpowered speakers and if it does, the volume willbe very low.Speaker ConnectionThe spring clip speaker terminals deliver amplified, speaker-level signals as output and should be connected withthe passive speakers.Bluetooth Operation1. Press and hold the ON/OFF& MODE button for 3 seconds to turn on the power.2. Press the ON/OFF& MODE button again to choose Bluetooth mode, the indicator will light in blue. You will hearan activation sound from the unit.Turn on the Bluetooth feature of your audio device, search for “Lenco LS-480 / Lenco LS-500” and pair.3. Once your device is successfully paired with the unit, you will hear a short confirmation sound from the unit.4. Play and stream music from your device to the unit.Note: Bluetooth version - 5.0This product has a bluetooth reception function, you can not transmit any bluetooth sound with it: this means thatyou can receive wirelessly a bluetooth sound signal from an external source like a smartphoneTurntable Operation1. Press and hold the ON/OFF& MODE button for 3 seconds to turn on the power.2. It’s turntable mode by default after turning on the power, the indicator will light in red.3. Place the record on the turntable. Use the 45 RPM Adapter if necessary.4. Choose the right Anti-skating force.5. Remove the stylus protector from the stylus assembly.Note: To avoid stylus damage, make certain the included stylus guard is in place whenever the turntable is beingmoved or cleaned.6. Open the tonearm clip from left to right.7. Press the PLAY/STOP button once, the platter start turning.8. Gently pull up the tonearm from its rest and move it over the record where play is desired to begin. Use theTonearm Lift Lever to raise the Tonearm Lift and let the tonearm lay on it.9. Set the Tonearm Lift Lever back to the down position, the tonearm will descend slowly onto the record andbegin playback.10. When the music has finished to play, use the Tonearm Lift Lever to raise the tonearm and then return it tothe tonearm rest. To suspend the playback, repeat the same steps.11. Press the PLAY/STOP button again, the platter stop turning.12. Press and hold the ON/OFF& MODE button for 3 seconds to turn off the power.