ePRO DimmerOperator Manual V3.0148 COMPLIANCE STATEMENTS8.1 C Tick ComplianceThe ePRO Dimmer from LSC Lighting Systems (Aust) Pty. Ltd. has been designed and conforms to thefollowing standards:EN55015 (Limits and methods of measurement of radio disturbance of electrical lighting and similarequipment) .IEC60439 (Low-voltage switchgear and control gear assemblies)IEC60950 (Specification for safety of information technology equipment including electrical businessequipment).8.2 CE ComplianceAll LSC products with CE Compliance automatically comply with C-Tick requirements as per Section 182 ofthe Radio communications Act 1992. LSC Company Registration number is N921.8.3 DisclaimerLSC Lighting Systems (Aust) Pty. Ltd. has a corporate policy of continuous improvement, covering areassuch as product design and documentation. In light of this policy, some detail contained in this manual maynot match the exact operation of your product.In any event, LSC Lighting Systems (Aust) Pty. Ltd. can not be held liable for any direct, indirect, special,incidental, or consequential damages or loss whatsoever (including, without limitation, damages for loss ofprofits, business interruption, or other pecuniary loss) arising out the use or the inability to use this productfor its intended purpose as expressed by the manufacturer and in conjunction with this operating manual.Servicing of this product is recommended to be carried out by LSC Lighting Systems (Aust) Pty. Ltd. or itsauthorised service agents. No liability will be accepted whatsoever for any loss or damage caused byservice, maintenance or repair by unauthorised personnel. In addition servicing by unauthorised personnelmay void your warranty.8.4 Product of AustraliaAll LSC Lighting Systems products are proudly designed, manufactured and distributed from Australia andmeet the highest certification of “Product of Australia” in the Australian Made Campaign.