La Cornue CornuFé 1908 Installation And User Manual
Also see for CornuFe 1908: Installation and user guide
                                      | |
Contents
| 
Unpacking the Cooker HANDLING AND INSTALLATION INSTRUCTIONS14 Installation and User Guide GB “CornuFé 1908”08NOTINSTALFE8/GB-1Do not take any packaging off the cooker until it is directly in front of the place it is to be installed(unless it will not fit through a door in its outer packaging).The following instructions are to be followed by qualified personnel, trained tohandle extremely heavy loads. Usually, a single-oven cooker can be lifted by twopeople.1. In order to lighten the cooker, remove and set aside the drawer, the backsplash, the handrail,the oven accessories, the pan supports and any other accessories.2. Remove oven doors by engaging the latches on the hinges and by pulling the door back and up.3. Create a harness with four Installer’s straps.4. Twist the harness and tilt the cooker to place the harness.5. When lifting up stairs, the straps of the handlers at the bottom should be shorter so thecooker stays level.The back of the cooker should always face the inside of the ramp.Removing the Oven DoorTo remove the door, open the door fully. Swivel the locking‘U’ clips forward to the locking position (Fig. 1). To removethe oven door, grip the sides of the door, lift upwards andthen slide the door forwards (Fig. 2).Refitting the Oven DoorTo refit the door, slide the hinges back into their slots.Rotate the locking ”U” clips back to fit onto the hinges.2. HANDLING INSTRUCTIONS1. UNPACKING THE COOKERHANDLING AND INSTALLATION INSTRUCTIONS3. REMOVING AND REFITTING THE OVEN DOORFig. 1Fig. 2 |
Related manuals for La Cornue CornuFe 1908
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine