La Crosse Technology C84428 Instruction Manual

Also see for C84428: Manual User manual Quick setup guide Instruction manual Quick setup guide

Contents

La Crosse Technology C84428 Instruction Manual Manual pdf 11 page image

Page | 11Professional Remote Monitoring StationSensor Search | Sensor IDEach of your sensors has an individual ID number on the bar code of thesensor. This sensor ID is visible on your station by pressing the SENSORbutton.View ID numbers:• Press and release the SENSOR button to view individual station andsensor ID numbers. All other information will disappear temporarily.Search for all sensors:• While viewing sensor ID, hold the SENSOR button for 3 seconds tosearch for all sensors.• The station will search for all sensor ID numbers on the station.• The sensor reception icon will flash for each sensor while searching.• Allow up to 3 minutes to receive sensor signal.Sensor Update IntervalMPHWIND SPEEDTOPSPEED1 HRSensor: Change Required for Update Updates: No Change- Sensor Updates:Rain 0.007 inch (0.2mm) every 45 seconds every 3 minutesWind 0.5 mph (0.8 km) every 31.5 seconds every 3 minutesTemp/Humidity 0.9F (0.5 C) every 50 seconds every 3 minutes.Example: It does not rain everyday. When it is not raining the rain sensor will update every 3 minutes. When it is raining , the rainsensor will updated every 45 seconds.Delete Sensor IDOUTDOORIn the rare event you need to replace your sensor, you will first need todelete the old sensor ID from your station.1. Press and release the SENSOR button to view your sensor ID number.2. While viewing your sensor ID, hold the MINUS button for 5 secondsto delete your old sensor ID. Dashes will show for the ID number.3. Your station will search for a new sensor. Remove batteries from yourold sensor.4. Install batteries in your new sensor and allow up to three minutes foryour new sensor readings and ID to appear on your station.Note: When replacing your Thermo-hygro sensor, press the TX button(under the battery cover) to send a signal immediately. The Rain andWind sensors do not have a TX button.TX C/F