La Crosse Technology, Ltd. Page 4Search for Transmitter If the outdoor temperature is not displayed after three minutes, hold the SENSORSEARCH button on the Forecast Station for three seconds to search for theoutdoor transmitter. Next, remove the battery cover from the TX141TH-B transmitter then press the TXbutton to send a signal. If it still does not receive the outdoor temperature, remove the A/C cord and batteries from both theForecast Station and the transmitter for 15 minutes repeat setup instructions from step 1.Power the Forecast StationThe Forecast Station can be powered by the 5-volt A/C adapter or with batteries.A/C Power Adapter• Insert enclosed 5-volt A/C power adapter into a wall outlet, then into the Forecast Station.Batteries1. Remove battery cover. Slide tab down and pull off to remove battery cover.2. Install three new AAA batteries according to the polarity markings.• Do Not Mix Old and New Batteries• Do Not Mix Alkaline, Lithium, Standard or Rechargeable BatteriesIf the Forecast Station does not display indoor temperature after 60 seconds, remove adapter andbatteries and wait for at least 60 seconds before repeating the setup process.Install Batteries in the Outdoor Transmitter1. Slide the battery cover down, then lift off the back of the transmitter.2. Insert two new AA batteries into the transmitter. Observe the correct polarity (see markinginside battery compartment).3. Keep transmitter 5-10 ft. from the Forecast Station during setup.4. After 15 minutes, if the outdoor temperature shows on the Forecast Station, you can movethe outdoor transmitter outside to a shaded location within range of the Forecast Station.BatteryCompartment