Setup1. Insert 2-AA batteries (not included) into the TX141TH-Bv2 sensor.Observe correct polarity.2. Insert 5.0 volt AC cord into the outlet, then into the weatherstation.3. (Optional): insert 3-AAA batteries (not included) into the weatherstation. Observe correct polarity.4. Set time, date etc.5. After 5 minutes, place sensor outside in a shaded location.AAAA• The station will search for the atomic signal at UTC 7:00, 8:00,9:00, 10:00, and 11:00.• If there is no WWVB reception, the station will search for the atomictime signal every 2 hours until the WWVB time is received.• The atomic time signal icon will flash while searching. The towericon will be solid when it has connected.• After reception, this station will only search for the atomic signalafter midnight.• From normal time display, press and release the TIME SET buttonto search for the WWVB time signal.• Please be sure you have selected your time zone from the list in theSettings menu. When the Atomic time signal is received, the stationwill set to the time zone selected. Default is Eastern Time.• For information about WWVB visit:www.nist.gov/pml/div688/grp40/wwvb.cfmAtomic TimeT85847 www.lacrossetechnology.com/support Page | 2AAAAAAAAA