La Crosse Technology TX6 Instruction Manual

Also see for TX6: Instruction manual

Contents

battery installation

La Crosse Technology TX6 Instruction Manual Manual pdf 2 page image

QUICK SET-UP GUIDEHint: Use good quality Alkaline Batteries and avoid rechargeable batteries.1. Have the indoor station and outdoor remote 3 to 5 feet apart.2. Batteries should be out of both units for 10 minutes.3. Place the batteries into the outdoor remote first then into the indoor station.(All outdoor remotes must be started before the indoor station)4. DO NOT PRESS ANY BUTTONS FOR 10 MINUTES.In this time the display and sensor will start to talk to each other and the display will show both the indoortemperature and an outdoor temperature. If the station does not display both temperatures after the 10minutes please retry the set up as stated above. After both indoor and outdoor temperatures are displayedfor 10 minutes you can place your sensor outdoors and set your time.The remote sensor should be placed in a dry, shaded area. The remote sensor has a range of 80 feet. Anywalls that the signal will have to pass through will reduce distance. An outdoor wall or window will have20 to 30 feet of resistance and an interior wall will have 10 to 20 feet of resistance. Your distance plusresistance should not exceed 80 ft. in a straight line.NOTE: Fog and mist will not harm your remote sensor but direct rain must be avoided.Battery Installation:1. Remove the mounting bracket. The bracket snaps on and off easily.2. Remove the battery cover, by sliding the cover down.3. Observing the correct polarity install 2 AA batteries. The batteries will fit tightly (toavoid start-up problems make sure they do not spring free).4. Replace the battery cover by sliding upwards. Be sure battery cover is on securely.

/ 4

Related manuals for La Crosse Technology TX6