La Crosse Technology WS-2814U-IT Operation Manual

Also see for WS-2814U-IT: Operation manual

La Crosse Technology WS-2814U-IT Operation Manual Manual pdf 9 page image

P a g e | 9SETUP TROUBLESHOOTING: If the sensor data fails to display for any of the outdoor sensorswithin 10 minutes, (“- - -“are displayed), remove the batteries from all units for 1 minute and startthe Setup procedure again at Step 1.FUNCTION BUTTONSSETHold for 3 seconds to enter the SET mode, where the following can be changed: LCDcontrast, Manual time setting, 12/24 hour time display, Date setting, °F/°C temperatureunit, Wind speed unit, Rainfall unit, Pressure unit, Relative pressure reference setting,Weather tendency threshold setting, Storm warning threshold setting, Storm Alarm On/Off setting, Wind direction display type, and Factory resetPress to toggle between the display of Mode 1 or Mode 2:o Mode 1: "Wind speed + outdoor temp + 24 hr. pressure history graph"o Mode 2: "Gust + Dew Point temp + 72 hr. pressure history graph "In the weather alarm setting mode, press to switch the weather alarm On / OffIn the weather alarm setting mode, press and hold to adjust the weather alarm valueStop the weather alarm when ringing▲/DATEPress to toggle between the display of seconds or date in the time displayPress to increase the level of different settings in SET modePress and hold to re-learn the thermo-hygro sensor synchronizationPress to reset the MIN/MAX record when in MIN/MAX display modeStop the weather alarm when ringing▼/RAINPress to switch the rainfall display mode: Total, 1h, 24h, week, monthPress to decrease the level of different settings in SET modeSynchronize the display with the PC (see Heavy Weather Pro Software User’s Guide)(must use usb stick).Stop the weather alarm when ringingALARMPress to enter the time alarm and weather alarm setting modeConfirm particular alarm settingPress to exit the manual setting mode