La Crosse Technology WS-7047TWC Instruction Manual

Also see for WS-7047TWC: Instruction manual

Contents

La Crosse Technology WS-7047TWC Instruction Manual Manual pdf 6 page image

6• with the use of screws• using the adhesive tapeA. Mounting with Screws1. Remove the mounting bracket from the remote temperature sensor.2. Place the mounting bracket over the desired location. Through the three screwholes of the bracket, mark the mounting surface with a pencil.3. Where marked, start the screw holes into mounting surface.4. Screw mounting bracket onto the mounting surface. Ensure that the screws areflush with the bracket.B. Mounting with Adhesive Tape1. With a nonabrasive solution, clean and dry the back of the mounting bracket andthe mounting surface to ensure a secure hold. The mounting surface should besmooth and flat.2. Remove the protective strip from one side of the tape.3. Adhere the tape to the designated area on the back of the mounting bracket.4. Remove the protective strip from the other side of the tape.5. Position the remote temperature sensor in the desired location, ensuring that theindoor temperature station can receive the signal.III) The Indoor Weather StationThe indoor weather station can be mounted in two ways:• with the table stand•  on the wall with the use of a wall hanging screw (not included).A. Using the Table StandThe indoor weather station comes with the table stand already mounted. If you wish touse the table-stand all that is required is to place the indoor weather station in anappropriate location.B. Wall Mounting1. Remove the table stand.2. To do this, pull down on the stand from the rear and rotate forward.3. Fix a screw (not included) into the desired wall leaving approximately 3/16 of aninch (5mm) extended from the wall.4. Place the indoor temperature station onto the screw using the hanging hole on thebackside.5. Gently pull the station down to lock the screw into place.OPERATION OF THE WIRELESS WEATHER STATION