La Crosse Technology WS-8011UM Instruction Manual

Also see for WS-8011UM: Instruction manual

Contents

La Crosse Technology WS-8011UM Instruction Manual Manual pdf 5 page image

9(c) Press the “ALARM” button to confirm the hour, and to set the alarmminutes.(d) The alarm minutes flash, press the “+” button to set the alarm minutes.(e) Press the “ALARM” button to confirm and to exit the alarm settingmode.Note: The alarm will be automatically set to sound when exiting thealarm-setting mode (indicated by the alarm “sound” icon to the rightof the time).2) ACTIVATING/DEACTIVATING THE ALARM(a) The alarm will be automatically set to sound when exiting the alarm-setting mode (indicated by the alarm “sound” icon to the right of thetime).(b) Press the “ALARM” button to activate and deactivate the alarm. Thealarm “sound” icon to the right of the time will appear or disappear,and the alarm time will be displayed briefly before returning to thenormal display mode.3) ACTIVATING THE SNOOZE FUNCTION(a) While the alarm is sounding, press the “SNOOZE” button to activatethe snooze function. The alarm “sound” icon and “SNOOZE” icon (tothe right of the time) will flash. The duration of the snooze function is10 minutes, then the alarm will resume.4) SUSPENDING ALARM(a) While the alarm is sounding or the SNOOZE is active, press the“ALARM” button to suspend the alarm until the next day.C) INDOOR TEMPERATUREThe Indoor Temperature appears on the right side of the Date LCD. Thetemperature is checked every 10 seconds, and updated whenever there is achange.D) REMOTE TEMPERATUREThe remote temperature will be shown on the right side of the lower LCDscreen. The Weather Temperature Station receives the outdoor temperature (For C) from the Remote Temperature Transmitter, and the temperature appearsin the OUTDOOR LCD. The Remote Temperature Transmitter transmits a newtemperature to the Weather Temperature Station 3 times every 10 minutes.10MOUNTINGThere are two possible ways to mount the Temperature Clock: 1) use of the foldout tablestands, or 2) wall mounting.E) FOLDOUT TABLE STANDSThe Foldout table stand legs are located on thebackside, at the lower corners, and on both sides ofthe battery cover. The hinges are towards the edgesof the Temperature Clock, and the ends (with nohinge) need to be folded out towards the edge. Oncethe Foldout table stands are extended, place theTemperature Clock in an appropriate location.F) WALL MOUNTING1) Using a straightedge, horizontally space at 3-15/16 of an inch (100.58mm) three screwpositions on a wall.2) Install three mounting screws (not included) intoa wall within transmission range—leavingapproximately 3/16 of an inch (5mm) extendedfrom the wall.3) Place the Temperature Clock onto the screws, using the hanging holes onthe backside. Gently pull the Temperature Clock down to lock the screwsinto place.IV) THE REMOTE TEMPERATURE TRANSMITTERA) The Remote Temperature Transmitter can be mounted in two ways: 1) with theuse of screws, or 2) using the adhesive tape.Hanging HolesFoldout Table StandsFunction Buttons