La Crosse Technology WS-9023U Instruction Manual

Contents

La Crosse Technology WS-9023U Instruction Manual Manual pdf 4 page image

4INVENTORY OF CONTENTS1. Wireless Weather Station (Figure 1)2. Wireless Thermo-Hygro Sensor (TX21U)and mounting bracket. (Figure 2)3. 3 each, 1/2” Philips screws.4. One strip of double sided adhesive tape.5. Instruction Manual and Warranty Card.ADDITIONAL EQUIPMENT(not included)1. 1 Philips screwdriver.2. 4 Fresh “AA” 1.5VAlkaline Batteries.QUICK SETUPHint: Use good quality Alkaline Batteries; avoid rechargeable batteries.1. Have the Wireless Weather Station and thermo-hygro sensor 3 to 5 feetapart.2. Batteries should be out of both units for 10 minutes.3. Place the batteries into the thermo-hygro sensor first and next into theWireless Weather Station.4. DO NOT PRESS ANY BUTTONS FOR 15 MINUTES.In this time the Wireless Weather Station and the thermo-hygro sensor will begin tocommunicate with each other, and the display will show both the indoor temperatureand an outdoor temperature. If the Wireless Weather Station does not display bothtemperatures after the 15 minutes, please retry the set up as stated above. After bothindoor and outdoor temperatures are displayed for 15 minutes you can place yourthermo-hygro sensor outdoors, and set your time.The thermo-hygro sensor should be placed in a dry, shaded area (ex: under the eve ofa roof). The thermo-hygro sensor has a range of 330 feet. Any walls that the signal willhave to pass through will reduce distance. An outdoor wall or window will have up to 20feet of resistance and an interior wall will have up to 10 feet of resistance. Yourdistance plus resistance should not exceed 330 feet in a straight line.NOTE: Fog and mist will not harm your thermo-hygro sensor, but direct rain must beavoided.DETAILED SETUP GUIDEI. BATTERY INSTALLATION (When one Thermo-hygro sensor is being used)1. First, insert the batteries to the Thermo-hygro sensor (see “A. Thermo-hygrosensor” below).2. Within 2 minutes of powering up the sensor, insert the batteries to theTemperature Station (see “B. Wireless Weather station” below). Once thebatteries are in place, all segments of the LCD will light up briefly. Following theFIGUREWirelessThermo-hygroSensorMountingBracket