La Crosse Technology Weather Direct WD-3308 Owner's Manual

La Crosse Technology Weather Direct WD-3308 Owner's Manual Manual pdf 8 page image

Version 1.0 - 11/7/2008Page 8 of 25Wireless Outdoor Sensor Installation Options NOTE: Move the Wireless Outdoor Sensor into its intended location and wait for10 minutes to make sure the outdoor temperature is still being received by theWireless Display. Press the “SNOOZE” Key on your Wireless Display to showthe outdoor temperature. If the display shows - -,-F for the outdoor temperature,the signal cannot reach the Wireless Display. Find a closer location to mount theWireless Outdoor Sensor and wait 10 minutes to check the Wireless Displayagain for reception. DO NOT mount the Wireless Outdoor Sensor in a permanent fashion untilyou are sure the signal is being received by the Wireless Display.To Surface Mount the Outdoor Sensor:We have provided a mounting plate that you can attach to a surfacewith the supplied screws. The Sensor can be positioned on a flatsurface by securing the stand to the bottom by gently pushing thebottom of the Sensor onto the holding pegs of the stand until theyclick into place in the grooves on the Sensor.To Wall Mount the Outdoor Sensor:The Outdoor Sensor is weather resistant, but not water proof. Toensure maximum Sensor life, mount it in a covered place out of theelements like under the eaves. Placement on the North side of yourhome will provide the most accurate readings. Mount it about 18”down from the eaves for optimum performance. This ensures that theweather data collected by the Outdoor Sensor will not be affected bythe temperature of the air leaving the attic.We have provided a mounting plate that you can attach to the wall with thesupplied screws. Gently snap the Sensor onto the holding pegs on the mountingplate after the plate is screwed to the wall. When the holding pegs are securelylocked into the slots on the Sensor, you will hear a “Click”.Gateway InstallationThe Gateway should be installed indoors in aneasy-to-reach location. Registration requiresthat you press the gray button on theGateway. It can be mounted securely to thewall with the included mounting plate anddrywall anchors.