LaCie 12big Rack Fibre and expansion Completing the InstallationQuick Install Guide page 10Enter a “new” password and confirm the new password.6.Click the Configure button.If you have additional Uninitialized Systems, select the next7.MAC address and choose the appropriate settings from theprevious steps.Once you have completed configuring all the UninitializedSystems and have clicked the Configure button, the wizardwill display a popup message indicating all systems havebeen configured. It will then re-scan for Uninitialized Systemsand if none are found, you will be taken to the InitializedSystems screen.However, if you wish to only configure one UnitializedSystem, the one you are configuring, and choose notto configure any other discovered Uninitialized System,click the Next button. You will receive a prompt that youhave not configured all systems. Click the YES button tocontinue or NO to cancel and return to the UninitializedSystems screen.Select the MAC address of the Initialized System you8.wish to start and click the Launch button. StorView willstart up.Your web browser will open with a login screen. Enter9.the login name and password then click OK. StorViewwill open in the browser at the Main screen.login: admin10.password: passwordiMPoRTanT noTe: If you are finished starting up EmbeddedModules, be sure to select the active Embedded StorView SetupWizard window in the Windows Task Bar and click the Close button.Figure 15: Uninitialized Embedded SystemsThe embedded module is identified by its MAC and IP ad-dress. It may be more helpful during setup to configure oneembedded module at a time. You will find the MAC and IPaddress by accessing the VT-100 RAID Configuration Utility,selecting Diagnostics then choosing StorView Embedded ModuleSupport. Select Enter StorView Embedded Module Menu Modeand selecting View Network Settings.Setting up the Embedded StorView Module:Microsoft WindowsInsert the Software and Manuals Disc into your CD disk.1.The autorun program will automatically start thenavigation menu.Click the2. Embedded StorView Setup Wizard link to beginthe configuration.You are presented with a “Welcome” screen and3.instructions to proceed. Review the information.Click the4. Next button. The program will begin searchingfor Embedded StorView Modules.Those Embedded Modules with their default passwordintact will be displayed with their MAC address in anUninitialized Systems list window.From the “Uninitialized Systems” screen, select the MAC5.address of the Embedded Module you wish to configure.If you wish to use a DHCP server to assign your IP ad-dress, click the check box Use DHCP.If you wish to manually configure your network setting,enter the correct information in the appropriate fields.Figure 16: Initialized Embedded Systems