Laars NeoTherm NTV Service Manual

Contents

Laars NeoTherm NTV Service Manual Manual pdf 98 page image

88 Service Manual - NeoTherm 500On the right side of the controller (reading top to bottom):• Disconnect connector CP6 from J6• Disconnect connector CP5 from J5• Disconnect connector CP4A from J4 (upper part)• Disconnect connector CP4B from J4 (lower part)At the lower center of the controller:• Disconnect the large orange spark cable5. Now you can remove the controller itself. The controller is attachedto the support plate by four clips. To remove the control, push thelower ends of the left side clips, and swing the left side of the controltoward you.Green connector mounted infar right positionJ2 J1CP10/ J10CP9/ J9CP8A/ J8CP8B/ J8J6/ CP6J5/ CP5J4/ CP4AJ4/ CP4BSpark cableRemoving and Replacingthe SOLA Controller (continued)Fig. D9-2 - Connectors on the SOLA controller6. Mount the new controller usingthe four clips.7. Replace the wires and cableslisted above. The cables andconnectors are all labeled.8. Replace the front cover andturn on the power to the unit.9. You may need to reset the con-trol on initial startup. Press the“OK” button to reset the control.D9cont.