Labgear LLP12K User Manual
Installation InstructionsCongratulations on the purchase of your log periodicaerial. The aerial is ideal for the reception of all avail-able signals in strong and medium areas.For optimum results install the aerial using double screened CAI approveddigital coax cable and screened coax outlets. You will need to fit the coaxcable with the F type connector supplied to connect to the downlead(not supplied) to the F socket on the aerial.1. Prepare the Coax Cable: Firstly fit the rubber weather bootprovided, to the aerial end of the cable. Strip the end of thecable as shown in Fig. 1. Once you have stripped the cable,twist the braid and pull it back on itself, make sure that nobraid is touching the copper core, this will cause a short onthe cable and you will not get any signal.2. Fitting the F connector: Now, simply twist onthe ‘F’ connector supplied and trim the central conductor.For best results the aerial should be mounted on an outdoor aerialmast and pointed in the direction of the nearest transmitter*making sure it is in a position where the transmitter signal will not beobstructed by nearby trees and buildings. If you are in any doubtabout the direction in which the aerial should be pointing or theorientation of the aerial (horizontal for main transmitter, vertical forrelay transmitter) check your neighbours’ aerials.The plate for the bracket has extra holes drilled at right angles toallow vertical mounting of the aerial.The aerial comes fully assembled. If mounting on an existing mastcheck that the mast is in good condition and firmly fixed.3. Use the mast clamp supplied and tighten the wing nutstightly until the aerial is held firmly in ahorizontal position as shown in Fig. 3 and 4.• Built in filter removes any signals from Lte 800 4Gmobile phone transmitters• F type connection• Superior rejection of impulse noise - the largestcause of picture freezing and signal dropout onFreeview reception• Gain 7.5dBi• Highly directional• Very low wind resistance• Supplied fully assembled with mast clamp,F connector and rubber weather bootCompact Log-PeriodicTV Aerial GRP KLLP12KUser GuideSupport: www.labgear.co.uk/support 1Do not undertake work outdoors at height unless you arecompetent in the use of ladders and other access equipment.Always use correct equipment, observe appropriate safetyprecautions and follow manufacturers instructions. If in doubt con-sult a professional installer.Before starting installation check structure is sound and check for hid-den wiring or plumbing.When working on an installation outside, beware of overhead power lines.Observe safe working practices, tread carefully on roofs and ensureadequate lighting is available if working in loft or roof space.Before making any connections switch electricity off at the mains.To avoid injury always route cables or wiring carefully. Ensure cableis correctly routed before fixing into position, taking care not toovertighten cable clips.This kit contains small parts - keep out of reach of children.After installation make regular maintenance checks for wear and tear.Full HDHDFilterFig. 1fold braid backover sheathinnerwirecut or tearaway foil6.5mm8mm2mm approx.Fig. 2screw connectorbody onto cableGeneral Safety PrecautionsFig. 3aFig. 3b |
Related manuals for Labgear LLP12K
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine