Manuals database logo
manualsdatabase
Your AI-powered manual search engine

Labkotec SandSET-1000 12 VDC Installation And Operating Instructions Manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Contents
  1. Table Of Contents
  2. GENERAL
  3. INSTALLATION
  4. SET/S2 sensor
  5. OPERATION AND SETTINGS
  6. Factory settings
  7. TROUBLE-SHOOTING
  8. REPAIR AND SERVICE
  9. TECHNICAL DATA
  10. DECLARATION OF COMFORMITY
  12. DECLARATION OF CONFORMITY
Labkotec SandSET-1000 12 VDC Installation And Operating Instructions Manual Manual pdf 4 page image
SandSET-1000 12 VDC Sludge Alarm Device D15649_E-2Installation and Operating InstructionsCopyright © 2019 Labkotec Oy 4/13 We reserve the right for changes without notice2 INSTALLATION2.1 SandSET-1000 12 VDC control unitSandSET-1000 12 VDC control unit can be wall-mounted. Themounting holes are located in the base plate of the enclosure, beneaththe mounting holes of the front cover.The connectors of the external conductors are isolated by separatingplates. The plates must not be removed. The plate covering theconnectors must be installed back after executing cable connections.The cover of the enclosure must be tightened so, that the edges touchthe base frame. Only then do the push buttons function properly andthe enclosure is tight.Before installation, please read the safety instructions in chapter 6 !Kuva 3. SandSET-1000 12 VDC alarm device installation.
/ 13
This manual is suitable for:
SandSET-1000 12 VDC
Manuals database logo
manualsdatabase
Your AI-powered manual search engine