Lacon L-EL900 Quick Start Manual
                  | |
Hardened Media Converter10One-Channel Media ConverterPortsThe Converter provides one TX port and one FX port. For the FX port, itprovides options ofy Multi-mode fiber using SC or ST connector ory Single-mode fiber using SC or ST connector ory WDM fiber using single SC connectorFor the TX port, it uses RJ-45 connector, auto-MDIX, and auto negotiates10/100Mbps and full/half-duplex.Port SettingsPort settings are made very simple by means of a DIP (Dual InlinePackage) switch at the front panel of the harden media converter.DIP switch settings:DIP switchThere are six pins on the DIP switch for port settings. Refer to the table belowfor more details.DIPswitchNo.0 11 Disable LFPT Enable LFPT LFPT:link fault passthrough2 Enable auto negotiation for TX port Enable forced mode for TX port3 TX port forced to 100Mbps TX port forced to 10Mbps4 TX port forced to full duplex mode TX port forced to half duplex mode5 FX port forced to full duplex mode FX port forced to half duplex mode6 Disable link down alarm Enable link down alarmy First, disconnect the converter from the power. Then toggle Pin 2 of theDIP switch to position 1 to enable the forced mode for TX port. |
Related manuals for Lacon L-EL900
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine