Lafalink XD9800 Quick Installation Manual
Contents |
2300Mbps CeilingWireless Access PointQuick Installation Guide300Mbps CeilingWireless Access PointQuick Installation Guide1Hardware and Operation ModeInterfaceGateway ModeAccess Point ModeRepeater ModeAP Mode AP Mode AP ModeAP Mode Repeater ModeRouter/SwitchOperation ModeThank you for purchasing the Ceiling AP.This manual suit for quick installation of indoor300Mbps 11N wireless AP & High Power Router.This manual will instruct you how to configureand manage indoor 300m 11N wireless AP &High Power Router in right ways.IntroductionPower LEDWi-fi LEDData LEDLEDRST: Reset Button,and hold the RESET button for at least 18 seconds when thewifi led is off, and then the AP reboots to its factory default settings.WAN/LAN: The Ethernet port is used to connect the power and should beconnected to the LAN and DHCP server.LED: When the Ethernet Port is connect with cable to other device, is FlashingGatewayRouter/SwitchAs belows shows.Installation StepsHareware ConectionCeiling APSetting the AP through WirelessRouter/SwitchPoE Power SupplySetting the AP using WirelessConnect the Switch or Router’s Ethernet Port to PoE Power Supply’s LAN Port, and connectthe PoE Power Supply’s PoE Port to AP’s WAN port. The computer using wireless to connectthe Ceiling AP (SSID XD9800,Key:66666666), and then log the 192.168.188.253 to setting theAP using the IE Browser.Hardware ConnectionSetting the ComputerLog in the Web ManagementSetting the APTest the Wireless NetworkInstall the AP to the CeilingNote:1. Before Install the AP on the Ceiling, you wouldbetter complete the software setting.2. Before the setting of the AP, you would bettercomplete the design of Topology of networkand IP address the devices.Hardware Connection Setting the ComputerPower for Wireless AP1. Using IEEE 802.3af PoE Switch to supply the Power to the Wireless AP2. Using PoE Power Adapter to supply the Power to the Wireless AP3. Using DC Power Adapter 12V1A to supply the Power to the Wireless APSetting the AP through Wires with RJ45 CableCeiling APPOE Power SupplySetting the AP using WiresConnect the PoE Power Supply’s PoE Port to AP’s LAN port. The computer using wires toconnect the PoE’s LAN Port, and then log the 192.168.188.253 to setting the AP using theIE Browser.Setting the AP through Wirelesssame network segment as AP, subnet mask 255.255.255.0192.168.188.X1883 (To be continued...)the default Passwords is"66666666"segment as the AP subnet mask 255.255.255.0 As belows shows.Log in the Web ManagementSetting the APSetting the AP through Wires with RJ45 Cablea.Open your web browser, type 192.168.188.253 in the address barb.enter the User name/Passwords: preset as admin/admin, then you can found onthe label attached to the router, click OKEnter into the page of WEB software management page, then set ceiling AP asrequirement. The default working mode is AP.XD9800ZHH1889508S188Internet Setting: The AP will settingto Gateway Mode;Wireless Repeater:The AP will settingto Repeater Mode;Wireless Coverage:The AP will settingto APMode;System Tools: PING ToolsAdvanced Settings |
Related manuals for Lafalink XD9800
manualsdatabase
Your AI-powered manual search engine