Laguna Tools REVO 1216 Owner's Manual

Also see for REVO 1216: Owner's manual

Laguna Tools REVO 1216 Owner's Manual Manual pdf 17 page image

2. Setup17 2. SetupREVO 1216 Lathe © 2018 Laguna Tools 10/22/2018EN1216 StandSKU: ALAREVO12 STANDFits: MLAREVO 1216-110FAQQ: What is the height range with this stand?A: The REVO 1216 Stand allows the spindlecenter line to be positioned at 7 different heightsfrom 39.6" to 44.6".Q: Does this come with the mobility kit?A: No, it comes standard with leveling casters.Fig L005: Stand for REVO 1216 10". Includes adjustable lathe stand and tool rack. (1) Inlowest 29.6" (floor to spindle center-line) position. (2) In Highest 29.6" position. (3) ToolRack - holds faceplate, both centers, knock out rod, 9 chisel tools with 1" holes, and 4 largetools with 1.5" holes.WARNING! Unplug machine from power prior to proceeding!CAUTION! Two persons is required in this set-up.NOTICE! Do not over torque the threading, firm pressure is all that is required.Fig L016: Receiving and un-boxing the ALREVO12 Stand. (1) Un-boxing Contents. (2) Standin box. (3) Components un-boxed.ReceivingIt is likely that your machine will be delivered by a third party. Before un-boxing, besure to inspect the packaging and shipping documents supplied by the driver.Ensure that there is no visible damage to the shipment. If any damage has occurredbecause of shipment, note the damage on the bill of lading or refuse the shipment.Immediately call the dealer store where the machine was purchased.1. Never accept a shipment that is damaged or partial without notifying theshipping company and the purchasing store.Un-boxingOnce in place, carefully un-box and remove all components. Un-boxing guidelines:1. Do not cut deep into a box with a blade as it could scratch the paint, only cutdeep enough to cut the tape or use a dull edge.2. Organize the hardware and setup tools needed (at beginning of each set-upsection) prior to proceeding with setup.