83-507-013 Rev. A81.2.9 Cooling and mechanical constructionThe Genesys TM series is cooled by internal fans. At the installation, care must be taken to allow free air-flow into the power supply via the front panel and out of the power supply via the rear panel. The Gene-sys TM power supplies have a compact and lightweight package, which allows easy installation and spacesaving in the application equipment.CAUTION1.3 ACCESSORIES1.3.1 GeneralAccessories are delivered with the power supply or separately upon ordering. The list below shows thepossible accessories and ordering numbers.1.3.2 Serial Link CableSerial link cable, for linking power supplies by RS485 communication is provided with the power supply.Cable description: 0.5m length, shielded, RJ-45 type plugs, 8 contacts (P/N:GEN/RJ-45).1.3.3 Misc. hardware∗ DB25 plug (AMP, 745211-2).∗ Strain relief for AC cord (for 1500W models only).∗ Output terminal shield1.3.4 AC cablesAC cables are not provided with the power supply. If an AC cable is required, it should be ordered ac-cording to following:For 750W Genesys TM power supplies:Part No. Market DescriptionNC301(GEN/U)USA 13A 125V, unshielded, 2m typical length, with IEC320 connector on one endand NEMA-5-15P connector on the other end.NC302(GEN/E)Europe 10A 250V, unshielded, 2m typical length, with IEC320 connector on one endand INT’L 7 standard VII, dual earthing.NC303(GEN/O)General 10A 250V, unshielded, 2m typical length, with IEC320 connector on one endand unterminated stripped wires on the other end. Use the cable only withplug approved by the national safety standards of the country of usage.NC305(GEN/J)Japan 13A 125V,unshielded, 2m typical length, with IEC320 connector on one endand Japan type plug on the other end.NC306(GEN/GB)UK 10A 250V unshielded, 2m typical length, with IEC320 connector on one endand UK type plug on the other end.For 1500W Genesys TM power supplies the recommended AC cable (customer supplied) is:25A 250V, 3x12AWG, outer diameter: 9-11mm, rated 60°C min., 3m max.length. Add a non-locking plug approved by the national safety standards ofthe country of usage.1.3.5 Serial Port Cables Refer to Section 7.5Observe all torque guidelines within this manual. Over-torquing may damageUnit or accessories. Such damage is not covered under manufacturers war-