Lampo IP30 User Manual
                   | |
3InstallationThe power supply is studied for ceiling, false ceiling, wall installation orsimilar structures.Led Power RGB has 4 fixing holes diameter 4mm. Use this holes to fix thepower supply, distance of holes is 293x44mm.Connect the projector to the power unit using the projector cable with RJ45connector or standard straight patch cable with RJ45.Example of installationIf only one Led Power RGB is on stand alone mode the signal cable is not necessary.If the Led Power are driven by a DMX controller or Led Power Master drive other Led Power Slave, they need to be connectedtogether, with DMX signal cable, following the instructions of this manual.The DMX signal is generated by a DMX controller, the signal cable goes in and out from each power unit up to the last one.More Led Power RGB will execute the same scenes if the DMX addresses are the same (factory set is 1) or they can be drivenone by one if the DMX addresses are different from each other.In the pictures below, projector is Led Power RGBDefault mode 7C d: each projector uses 8 DMX channelsLed Power 1: DMX address 1 Led Power 2: DMX address 9 Led Power 3: DMX address 17……If the DMX controller is not switched on, the projectors can be in black-out mode, generate light at 15% (default setting) orgenerate light at 100%. Change this parameter at – DM.DE of menu.It is possible to use MASTER/SLAVE function: One projector (Master) functioning in stand alone mode with residentprograms and a group of projector (Slave) execute, thanks to dmx signal and signal cables, the same sequences of colours.The projectors can be fed from different power sources, it is not necessary to switch on the projectors at the same time. |
Related manuals for Lampo IP30
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine