Lampo IP65 User Manual

Also see for IP65: User manual User manual User manual

Contents

Lampo IP65 User Manual Manual pdf 14 page image

13Stand alone mode (colour sequences)For the stand alone mode (STAND ALONE/MASTER), the dip-switch 12 has to be on the ON position. When the projector isswitched on, it will execute the functions set on the dip-switches.If the projector has to execute colour sequences, the dip-switches 4 has to be on OFF position.WARNING: The projector in stand alone mode becomes a DMX generator, it is necessary to disconnect that projectorby DMX controller or by the other projector MASTER because generates conflict in the signal.Setting the dip-switches 1, 2, 3, it is possible to choose the colour sequence that the projector will execute.Setting the dip-switches 5, 6, 7, it is possible to choose the colour changing time between two colours.Setting the dip-switches 8, 9, 10, 11, it is possible to choose the colour holding time for each colour.DIP-SWITCH FUNCTIONDip 1 MODE 1Dip 2 MODE 2Dip 3 MODE 3Dip 4 OFFDip 5 CHANGING TIME 1Dip 6 CHANGING TIME 2Dip 7 CHANGING TIME 3Dip 8 HOLD TIME 1Dip 9 HOLD TIME 2Dip 10 HOLD TIME 3Dip 11 HOLD TIME 4Dip 12 ONCOLOUR SEQUENCE SETTINGAs shown in the following table the projector will execute the colour from top to bottom and back.Dip 1 off ON off ON off ON off ONDip 2 off off ON ON off off ON ONDip 3 off off off off ON ON ON ONWhite Azure Azure Yellow Azure Magenta White WhiteBlue Blue Orange Orange Red Yellow Red BlueMagenta Orange Light green Magenta Green Azure Green RedRed Cyan Dark green VioletYellowGreenColoursequenceCyanCOLOUR CHANGING TIME SETTINGSetting the dip-switches 5, 6, 7, it is possible to choose the colour changing time between two colours.Dip 5 Dip 6 Dip 7 Secondsoff off off 1ON off off 5off ON off 10ON ON off 20off off ON 40ON off ON 60off ON ON 120ON ON ON 240