Lampo Supertracer 2500 HTI User Manual
                 | |
9CONTROL SYSTEMSTRACER CONTROL UNITSUPERTRACER comes with a control unit mounted on the adjustable bar and connected to the projector bymeans of a proper cable through 9 pin din connector. The TRACER CONTROL UNIT is powered at low voltage 12Volts directly by the projector and it is able to control the fixture in all its functions.It is necessary to know that SUPERTRACER can be controlled by practically all types of controllers on the marketthat can execute the standard DMX 512 protocol. Controller-projector and projector-projector connections require atwo-core screened cable provided with CANNON PLUGS AND SOCKETS. SUPERTRACER can use both 3 or 5pin CANNON plugs and sockets because it comes with 3- and 5 pin CANNON SERIAL PORTS. The ground braidon the screened cable must be connected to just one end of the cable. The projector and cables must not beinstalled near overhead ducts for electrical cables or intense magnetic fields.CONTROL FROM TRACER CONTROL UNITIn this mode, the projector is controlled directly from the on-board TRACER control unit.To better understand the working, we suggest to read carefully this paragraph and, if possible, to operate step bystep directly on the TRACER console or to refer to the TRACER console drawing.COLOUR SECTIONColours are controlled from here.Quick- select keys can be used to project the corresponding colour.Two-colour beams are projected when two adjacent keys are pressed simultaneously.When the Rainbow/Fixed Colours key is pressed, the projector will do the rainbow effect. Rotation speed iscontrolled by the colour section slider when the Rainbow LED is switched on. This function may be switched off bypressing the Rainbow/Fixed Colours key again or any of the quick-select COLOUR keys.FILTER CORRECTION SECTIONTemperature correction filters and frost filter are controlled from here.The colour temperature correction filter keys is used to set primary colours (5600°K), warm colours (3200°K CTO)or cold colours (6500°K CTB). The FROST filter key is used to obtain soft beam using. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine