282 Hardware InstallationJumper SettingsIf you encounter the following,a) CMOS data becomes corrupted.b) You forgot the supervisor or user password.c) The overclocked settings in the BIOS resulted to the system’s in-stability or caused system boot up problems.you can reconfigure the system with the default values stored in theROM BIOS.JP8 is accessible from the rear panel of the system. This providesconvenience by allowing you to clear the CMOS without having toremove the chassis cover.To load the default values stored in the ROM BIOS, please followthe steps below.1. Power-off the system then unplug the power cord.2. Set JP2 or JP8 pins 2 and 3 to On. Wait for a few seconds andset JP2 or JP8 back to its default setting, pins 1 and 2 On.3. Now plug the power cord then power-on the system.Clear CMOS Data2-3 On:Clear CMOS Data1-2 On: Normal(default)JP2JP8X2-3 On:Clear CMOS Data1-2 On: Normal(default)132132X31 231 2
