CopyrightThis publication contains information that is protected by copyright. No par t of itmay be reproduced in any form or by any means or used to make any transfor-mation/adaptation without the prior written permission from the copyrightholders.This publication is provided for informational purposes only. The manufacturermakes no representations or warranties with respect to the contents or use ofthis manual and specifically disclaims any express or implied warranties ofmerchantability or fitness for any par ticular purpose. The user will assume theentire risk of the use or the results of the use of this document. Fur ther, themanufacturer reserves the right to revise this publication and make changes to itscontents at any time, without obligation to notify any person or entity of suchrevisions or changes.© 2008. All Rights Reser ved.TrademarksWindows ® 2000 and Windows ® XP are registered trademarks of MicrosoftCorporation. Award is a registered trademark of Award Software, Inc. Othertrademarks and registered trademarks of products appearing in this manual arethe properties of their respective holders.FCC and DOC Statement on Class BThis equipment has been tested and found to comply with the limits for a ClassB digital device, pursuant to Par t 15 of the FCC rules. These limits are designedto provide reasonable protection against harmful interference when the equip-ment is operated in a residential installation. This equipment generates, uses andcan radiate radio frequency energy and, if not installed and used in accordancewith the instruction manual, may cause harmful interference to radiocommunications. However, there is no guarantee that interference will not occurin a par ticular installation. If this equipment does cause harmful interference toradio or television reception, which can be determined by turning the equipmentoff and on, the user is encouraged to tr y to correct the interference by one ormore of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and the receiver.• Connect the equipment into an outlet on a circuit different from that towhich the receiver is connected.• Consult the dealer or an experienced radio TV technician for help.Notice:1. The changes or modifications not expressly approved by the party responsi-ble for compliance could void the user's authority to operate the equipment.2. Shielded interface cables must be used in order to comply with the emissionlimits.