LANCOM L-300 Access Point series Chapter 4: Security settings49EN4.3.2 WEBconfig WizardWith WEBconfig you have the option to launch the Check security settingsWizard to check and change any settings. The following values are edited: Device password The protocols to be available for accessing the configuration from localand remote networks The parameters for locking the configuration (the number of incorrectpassword entries and the duration of the lock) Security parameters such as WLAN name, closed-network function, WPApassphrase, WEP key, ACL lists, and protocol filters4.4 The security checklistThe following checklists provide an overview of all security settings that areimportant to professionals. Most of the points in this checklist are uncriticalfor simple configurations. In these cases, the security settings in the basicconfiguration or that were set with the Security Wizard are sufficient. Detailed information about the security settings mentioned here areto be found in the reference manual. Have you secured your wireless network with encryption andaccess control lists?With the help of 802.11i, WPA or WEP, you can encrypt the data in yourwireless network with different encryption methods such as AES, TKIP orWEP. LANCOM Systems recommends the strongest possible encryptionwith 802.11i and AES. If the WLAN client adapters do not support these,then you should use TKIP or at least WEP. Make sure that the encryptionfunction in your device is activated, and that at least one passphrase orWEP key has been entered and selected for application. For security reasons, LANCOM Systems strongly advises you not to useWEP! You should only ever use WEP under exceptional circumstances.When using WEP encryption, use additional security mechanismsadditionally.To check encryption settings, open LANconfig, go to the configurationarea and select ‘Wireless LAN’ on the '802.11i/WEP' tab to view the set-tings for the logical WLAN interfaces.