LANCOM L-54g Wireless - LANCOM L-54ag Wireless - LANCOM L-54 dual Wireless Chapter 4: Security settings41EN The wizard will inform you when entries are complete. Complete the con-figuration with Finish.4.3.2 Wizard for WEBconfigUnder WEBconfig you have the possibility to run the wizard Security settingsto control and change the settings. The following values are handled: password for the device allowed protocols for the configuration access of local and remote net-works parameters of configuration lock (number of failed log-in attempts andduration of the lock) security parameters as WLAN name, closed network function, WEP key,ACL list and protocol filters4.4 The security checklistThe following checklists provide an overview of all security settings that areimportant to professionals. Most of the points in this checklist are uncriticalfor simple configurations. In these cases, the security settings in the basicconfiguration or that were set with the Security Wizard are sufficient. Detailed information about the security settings mentioned here areto be found in the reference manual. Have you secured your wireless network with encryption andaccess control lists?With the help of 802.11i, WPA or WEP, you can encrypt the data in yourwireless network with different encryption methods such as AES, TKIP orWEP. LANCOM Systems recommends the strongest possible encryptionwith 802.11i and AES. If the WLAN client adapters do not support these,then you should use TKIP or at least WEP. Make sure that the encryptionfunction in your device is activated, and that at least one passphrase orWEP key has been entered and selected for application.To check the WEP settings, open LANconfig, go to the configuration areaand select ‘WLAN security’ on the '802.11i/WEP' tab to view the encryp-tion settings for the logical and physical WLAN interfaces.With the access control list (ACL) you can permit or prevent individual cli-ents accessing your wireless LAN. The decision is based on the MAC