LANCOM L- 54ag Wireless – LANCOM L- 54g Wireless – LANCOM IAP- 54 Wireless Chapter 2: Installation19ENNote that resetting the device leads to a loss on the WLAN encryptionsettings within the device and that the default WEP key is active again(’Standard WEP encryption’ →page 43).2.4 Hardware installation2.4.1 LANCOM L-54g Wireless, LANCOM L-54ag WirelessThe installation of the LANCOM 54 Wireless base station takes place in max-imum five steps: Antennas – Screw on the both included diversity antennas at the back ofthe LANCOM 54 Wireless base station. LAN – You can first connect the LANCOM 54 Wireless base station to yourLAN. For that purpose, plug the included network cable (green plugs) intothe LAN connector of the device and the other end into a free networkconnecting socket of your local network (resp. into a free socket of a hub/switch). In this case, the node/hub switch remains in the presetting'node' ( ).Alternatively, you can connect also a single PC. In this case, turn the node/hub switch on 'hub' ( ).The LAN connector identifies automatically the transfer rate (10/100Mbps) of the connected network device (autosensing).For information about the installation of PoE see the info box ’Power-over-Ethernet – elegant power supply through the LAN wiring’→page 17. DSLoL – If you want to use your LANCOM 54 Wireless base station inDSLoL mode, you can either connect the device directly to the DSL modem(exclusive mode) or to a hub resp. switch of the cable-bound LAN (auto-matic mode).For the exclusive mode insert the included network cable (green plugs)into the LAN connector of the device and the other end into the cor-responding interface of the DSL modem. In this case, turn the node/hubswitch on 'hub' ( ).For the automatic mode for simultaneous operating with LAN and DSLoLinsert the included network cable (green plugs) into the LAN connector ofthe device and the other end into a free network connecting socket of