Land Pride RB45108 Operator's Manual

Contents

Land Pride RB45108 Operator's Manual Manual pdf 10 page image

8Section 1: Assembly and SetupRB4596, RB45108 & RB5596 Rear Blade 301-133M 5/21/07Land PrideTable of ContentsBlade Offset CylinderRefer to Figure 1-6:Assemble hydraulic hoses to the hydraulic cylinderbefore placing cylinder on the blade.1. Position hydraulic cylinder with ports on top. Installtwo 90 degree elbows into the cylinder ports andtighten as needed.2. Screw 96" long hydraulic hoses into the elbows andtighten. Use 101” long hydraulic hoses when sing aQuick Hitch.3. Thread adapter fittings to the other end of thehydraulic hoses and tighten. (Hydraulic couplings notfurnished.)4. Attach hydraulic cylinder to the lugs located on eitherside of the Rear Blade with clevis pins. Make surehydraulic ports are positioned on top and the cylinderbase in positioned to the front as shown.5. Secure clevis pins with hair pin cotters.6. Route hoses through hose brackets located on top ofthe main frame and on the right side of the front hitch.Connect hoses to tractor's hydraulic system.IMPORTANT: Attach cylinder base to the front hitchlug. The cylinder base will interfere with the mainframe if attached to the rear lug.Blade Tilting CylinderRefer to Figure 1-6:Assemble hydraulic hoses to the hydraulic cylinderbefore placing cylinder on the blade.1. Position hydraulic cylinder with ports on top. Installtwo 90 degree elbows into the cylinder ports andtighten as needed.2. Screw 114" long hydraulic hoses into the elbows andtighten. Use 125” long hydraulic hoses when sing aQuick Hitch.3. Thread adapter fittings to the other end of thehydraulic hoses and tighten. (Hydraulic couplings notfurnished.)4. Attach hydraulic cylinder to the lugs located on theback of the Rear Blade with clevis pins. Make surehydraulic ports are positioned facing forward and thecylinder base in positioned up as shown.5. Secure clevis pins with hair pin cotters.6. Route hoses through hose brackets located on top ofthe main frame and on the right side of the front hitch.Connect hoses to tractor's hydraulic system.IMPORTANT: Attach cylinder base to the uppermounting lug.Hydraulic Tilt and Offset AssemblyFigure 1-615004Blade AnglingBlade Tilting