Landa EHW Series Operator's Manual

Landa EHW Series Operator's Manual Manual pdf 14 page image

14OperationsShutdown ProceduresSTEP 1: Rinse all lines (andinjector) with clean water, toremove any soap residue then turntoggle switch off.STEP 2: Turn off water supply. STEP 3: Open spray gun to relieveremaining pressure and removewater supply hose.In freezing conditions, disconnectwater supply and open spray gun toallow water to drain, then turn offmotor.CAUTION: Do not allow pump torun longer than 5 minuteswithout water. Disconnect allhoses to allow water to drain.CAUTION: With machine off,open spray gun to releasepressure before removingdischarge hose.Landa EHW Operator’s Manual 8.941-114.0 - MCAUTIONNever Use :• Bleach, chlorine products and other corrosive chemicals• Liquids containing solvents (i.e. paint thinner,gasoline,oil)• Tri-sodium phosphate products• Ammonia products• Acid-based productsThese chemicals will harm the unit and will damage thesurface being cleaned.Use manufacturer's detergents as recommended in manualToggleSwitchStoragePump StorageCAUTION: Always store yourpressure washer in a location wherethe temperature will not fall below32° F (0° C). The pump in thismachine is susceptible topermanent damage if frozen.FREEZE DAMAGE IS NOT COVERED BYWARRANTY.If you must store your pressure washer in a locationwhere the temperature is below 32° F, you canminimize the chance of damage to your machine bydraining your machine as follows:1. Stop the pressure washer and detach supply hoseand high pressure hose. Squeeze the trigger of thespray gun to drain all water from the wand andhose.2. Restart pressure washer and let it run briefly (about5 seconds) until water no longer discharges fromthe high pressure outlet.CAUTION