Landa vhp2-1500 Operator's Manual

Also see for vhp2-1500: Operator's manual

Landa vhp2-1500 Operator's Manual Manual pdf 11 page image

LANDA VHP • 8.913-949.0 • Rev. 5/1311PRESSURE WASHER OPERATOR’S MANUALvariable pressureControl handleTriggervariable pressureWand (vp)highpressurenozzlebrass soapnozzlesTep 6: Selection of high or low pressure is ac-companied by turning the handle. note: Highpressure nozzle must be inserted at end of wand toobtain high pressure. To apply soap read operator'smanual.sTep 5: Release the couplercollar and push the nozzle untilthe collar clicks. Pull the nozzle tomake sure it is seated properly.sTep 4: Pull the spring-loadedcollar of the wand coupler col-lar back to insert your choiceof pressure nozzle. CAUTION:Never replace nozzles withoutengaging the safety latch onthe spray gun trigger.CouplerCollaroperaTIng InsTruCTIonssTep 3: Before installing nozzle, Pulltrigger on spray gun allowing water to flowuntil all air has been discharged from thesystem. Check for water leaks and tightenas needed.Grip spray gun variable pressure wandsecurely. Then turn the variable pressurecontrol handle counterclockwise to flushany debris out of soap nozzle.89139490-6pump and burnerswitchsTep 9: Turn switch to pump position andpull the trigger on the spray gun. Turn vari-able pressure control wand handle clockwiseto obtain pressure for cold water operation.For hot water, turn the switch to the burnerposition and pull the trigger on the spray gun.To apply detergent, read section on Deter-gents and General Cleaning Techniques.sTep 7: Open valve on LP tank, then slightly depressmain gas valve control knob on the right side of the ma-chine and turn it counterclockwise to the Pilot position.noTe: Knob cannot be turned from “Pilot” to “OFF” unlessthe knob is slightly depressed.step 8: Depress the control knob all the way and hold it in. Afterfive (5) seconds, depress the red ignitor until you hear a loud click.Repeat 3 or 4 times if necessary until pilot is lit. If pilot does notremain lit, repeat operation allowing a longer period of time beforereleasing the gas valve knob. After the pilot lights, continue to holdthe control knob down for about one (1) minute before releasing.Look at the pilot viewing mirror at the rear of the machine.Turn gas control knob counterclockwise to “ON.”ControlknobgasvalveredIgnitor