Landoll SSB-8 Operator's Manual

Also see for SSB-10: Operator's manual

Contents

Landoll SSB-8 Operator's Manual Manual pdf 37 page image

ASSEMBLY INSTRUCTIONS2-15S-Tine Tire Track Remover1. Attach brackets to the frame with U-Bolts 1/2” x4-1/2” centers x 7-1/2” deep, Lock Washers, andNuts. Note that the long ends of the brackets aredownward. The brackets should be about 53 inchesfrom center of implement. See Figure 2-16.2. Attach the tube to brackets using straps and 1/2” x 6”Bolts, Lock Washers, and Nuts.3. Locate and install the S-tines as needed to cover thetractor tire tracks. The suggested pattern is to use1-3/8” point on center tine and 2-1/2” points on eachside. If needed, additional tines may be purchasedand installed. This kit must be used with standard9J442 long three point hitch on pickup implements.The Wheel Track Remover is furnished with 6 S-tines.Additional or fewer tines may be used as required.NOTES-tines should not be operated any deeper thannecessary to remove tractor tire tracks. Otherwise, wetsoil is brought up which will stick to the rollers, draft loadis increased, and under some conditions, tines maydeflect back to rollers and break.Figure 2-16: S-Tine SetupTractor Tire DepressionTooth TubeBracketAssemblyS-TineClampCarriageBolt2 1/2 Point1 3/8 PointSUGGESTED SETTING