ASSEMBLE WITH CARE! Pangard II Polyester Powdercoat is a strong, long‐lasting finish. Toprotect this finish during assembly, place unwrapped powdercoated parts on packaging foam orother non‐marring surface. Do not place or slide powdercoated parts on concrete or other hard ortextured surface – this will damage the finish causing rust to occur. Use touch‐up paint on anygouges in the finish caused by assembly tools.Tools required:• protective padding• 3/16 hex key• Anchoring hardware not included for surface mount units. Powers Fasteners Power‐Bolt® stainless steel 3/8” x 2‐1/4” hex head sleeve anchors are recommended. (4required)• Hammer drill with 3/8” diameter carbide tipped drill bit• Hammer• Wrench• 9/16” wrench (for seats)• 5/32” hex key• 7/16” wrench (for umbrella hardware)WARNING! TABLES MUST BE FASTENED SECURELY TO HARD SURFACING TOPREVENT TIPPING.Installation GuideCarousel standing height tablewww.landscapeforms.com Ph: 800.521.2546Date: June 21, 2018Page 1 of 3Standing ht SUPPORT ‘A’ Standing ht SUPPORT ‘B’FootrestIncluded components:• Support ‘A’ with surface mount tabs• Support ‘B’ with surface mount tabs• Footrest• Seats (qty and style depends on order)• 1 tabletop per unit, with attaching hardware• (1) ¼‐20 x 2‐1/4” Phillips pan head machinescrew and lock nut2X – 1/4‐20 x 7/8”Hex head cap screws2X – 1/4 washer30” dia tabletop,Marneaux or Catena27” square woodTabletop30” dia woodTabletop30” square MarneauxTabletopBacklessGrid seatBacklessperf seatBackedgrid seatBackedperf seatHoopseat4X ‐ 3/8‐16 x 1‐1/2” indented hexhead machinescrew4X ‐ 3/8 washerPROCEDURE FOR ASSEMBLING SUPPORTS: See Fig 1 and Fig 2Note: DO NOT DRAG unit across concrete or other rough surfaces. This coulddamage the powdercoat on the bottom of the surface mount tabs.1. Verify that surface mount tabs are securely fastened to support legs. Tighten ifnecessary.2. Slide support ‘A’ over support ‘B’. Align notch in support ‘A’ over bar in support‘B’. See Fig. 1.3. Slide footrest over assembled support legs, aligning the holes in the footrestwith the holes in the support bar.4. Secure footrest to support legs with (2) hex head cap screws and washers. SeeFig. 2.