Lang 224S Installation And Operation Instructions Manual

Also see for 224S: Installation, operation and maintenance instructions Installation & operation instructions

Contents

Lang 224S Installation And Operation Instructions Manual Manual pdf 8 page image

8INSTALLATIONElectrical ConnectionThe 120V griddles are supplied with a cord and plug, 240V units are not. The 120V receptacle is notprovided with the griddle.Follow the receptacle manufacturer’s instructions when connecting the receptacle to the power supply.Gas ConnectionThis griddle is manufactured for use with the type of gas indicted on the nameplate.Contact the factory if your type of gas does not match the nameplate data.All gas connectors must be in accordance with local codes and comply with the National Fuel FederalGas Codes ANSI Z223.1 latest edition.This appliance should be installed with a separate gas valve in the gas line ahead of the unit. Use a3/4 inch or larger gas supply line.Remove the 5/16 inch nuts securing the rear of burners. These nuts are for securing the main burnersduring transportation only. The rear burner shield must be removed to gain access to the nuts.A pressure regulator for the type of gas specified is supplied with each appliance.This regulator must be installed in the gas supply line. (Note the direction of the gas flow arrow.)The pressure in the manifold of the appliance should be tested with a manometer and the regulatoradjusted for proper pressure with the appliance operating at full fire. A 1/8 inch NPT tap is provided inthe manifold for connecting a manometer.Correct manifold pressures are:5 inches water column for natural gas10 inches water column for propaneWhen replacing the plug in the manifold, a pipe joint compound or sealant should be used that isresistant to the action of liquid petroleum gas.Initial adjustments are the responsibility of the installer and are not chargeable to Star ManufacturingInternational.After the griddle is in its final position, adjust the legs to create 1/8 inch slant from back to front.This will allow the grease to run into the grease gutter and provide the proper combustion air for theburners.DANGER: THIS APPLIANCE MUST BE GROUNDED AT THE TERMINALPROVIDED. FAILURE TO GROUND THE APPLIANCE COULDRESULT IN ELECTROCUTION AND DEATH.INSTALLATION OF THE UNIT MUST BE DONE BY PERSONNELQUALIFIED TO WORK WITH ELECTRICITY AND PLUMBING.IMPROPER INSTALLATION CAN CAUSE INJURY TO PERSONNELAND/OR DAMAGE TO EQUIPMENT. UNIT MUST BE INSTALLED INACCORDANCE WITH ALL APPLICABLE CODES.NOTICE: The data plate is located inside the control compartment of eachgriddle. The griddle voltage, serial number, gas specifications, andclearance specifications are on the data plate. This informationshould be carefully read and understood before proceeding withthe installation.NOTICE: The installation of any components such as a vent hood, greaseextractors, fire extinguisher systems, must conform to theirapplicable National, State and locally recognized installationstandards.WARNING