Lang ECCO-AP Installation Operation & Maintenance

Also see for ECCO-AP: Service manual Service manual

Contents

Lang ECCO-AP Installation Operation & Maintenance Manual pdf 8 page image

8INSTALLATIONDANGER THIS APPLIANCE MUST BE GROUNDED AT THE TERMINAL PROVIDED.FAILURE TO GROUND THE APPLIANCE COULD RESULT INELECTROCUTION AND DEATH.WARNING INSTALLATION OF THE UNIT MUST BE DONE BY PERSONNEL QUALIFIEDTO WORK WITH ELECTRICITY AND PLUMBING. IMPROPERINSTALLATION CAN CAUSE INJURY TO PERSONNEL AND/OR DAMAGETO EQUIPMENT. UNIT MUST BE INSTALLED IN ACCORDANCE WITH ALLAPPLICABLE CODES.NOTICE The data plate is located above control panel behind wire mesh screen. Theoven voltage, wattage, serial number, wire size, and clearancespecifications are on the data plate. This information should be carefullyread and understood before proceeding with the installation.NOTICE The installation of any components such as a vent hood, grease extractors,fire extinguisher systems, must conform to their applicable National, Stateand locally recognized installation standards.Leg InstallationLegs are available for both the single and double deck installations. Single deckinstallations require a 27-inch leg. Double deck installations require 6-inch legs orcasters.To install the 27-inch legs, place some cardboard on the floor and gently tip theoven onto its back. Fasten two legs to the oven's front corners using the four 5/16inch bolts provided in the leg kit. Lift the oven onto its front legs and block theback up using one of the 27-inch legs set upside down in the center rear of the ovenbody. Install the last 27-inch leg onto the oven body on the control side rear.Gently lift the oven rear, remove the leg set to support the oven center and install iton the last rear corner.To install the 6-inch legs or casters, follow the instructions in the Leg Pad sectionon the following pages or in the Leg Pad box supplied with the oven.The adjustable feet on the bottom of each leg may be screwed in or out asnecessary to level the oven.A torpedo level placed on an oven rack will assist in leveling the oven.Stacking the OvensRemove all the plug buttons from the top of the lower oven.Remove the stacking kit from the oven compartment of one oven and install the 11/4-inch plastic bushing into the top of the lower oven.Tip the top oven backwards and install two 3/8-inch socket head bolts, found in thestacking kit, into the two front leg holes that match the holes in the top of the loweroven. Install the socket head bolts with the heads of the bolt pointing away fromthe oven.Lift the top oven and gently set on top of the lower oven so that the heads of thesocket head bolts nest into the holes in the top of the lower oven.