Lang ECCO-C Installation Operation & Maintenance

Also see for ECCO-C: Service manual Service manual Quick programming guide

Contents

Lang ECCO-C Installation Operation & Maintenance Manual pdf 8 page image

6The STATUS READOUT will then display" ", at that time press the SHELFBUTTON(S) that match the shelf position(s) theproduct was placed on (A equals the top shelf, Eequals the bottom shelf).If the product program is a MULTIPLE TIEREDprogram, the operator has only one opportunityto enter a PRODUCT and SHELF selection. Thecomputer will not allow a second selectionduring the cooking cycle (see seperatePROGRAMMING instructions).When the product is done the STATUSREADOUT will display " ", the beeper willsound, and a SHELF BUTTON will flashindicating which product has finished baking.Pressing the SHELF BUTTON will turn off thebeeper and allow the oven to continue baking orgo to stand-by with the STATUS READOUTdisplaying " ".PRODUCT CHANGINGIf you wish to change to a product which isprogrammed at a different temperature you mustfirst press the READ/CLEAR button until" " is displayed in the STATUSREADOUT. Release the READ/CLEAR buttonand the STATUS READOUT will display" " and allow the selection of the newproduct.When a product which is programmed at adifferent temperature is selected, the STATUSREADOUT will display " " or " " until theoven has reached the programmed temperature.The computer will not allow a shelf selectionuntil the STATUS READOUT displays " ".Once the computer reaches the programmedtemperature the beeper will sound briefly and theSTATUS READOUT will display " "When the STATUS READOUT displays " "any PRODUCT BUTTON which is programmedat the same temperature will also light up.When a PRODUCT button is selected, thatbutton will flash slowly, indicating which productis being baked.TIME RECALLTo check the remaining cook time on a productthat is baking, press the corresponding SHELFbutton, the STATUS READOUT will display theremaining time on the cook cycle.CANCEL SHELFPress the READ/CLEAR button twice then pressthe shelf to be canceled. The STATUSREADOUT will display or the time forthe next to time to done.MANUAL PROGRAMMINGThe button on the control panel labeled MANPROG is the MANUAL PROGRAM button.The MANUAL PROGRAM (MAN PROG)button allows the operator in create a short-termprogram for one time products.The program will be erased when the oven isturned off or the READ/CLEAR button ispushed.The MANUAL PROGRAM button is active onlywhen the STATUS READOUT displays " ".To operate the MANUAL PROGRAM featurepress the MAN PROG button.The STATUS READOUT will display " ".Select the desired temperature using thePRODUCT buttons 0 through 9 to a maximumof 450 degrees.Once a temperature is entered the STATUSREADOUT will display " ". The control isasking for a cooking time input.Enter the desired cooking time using thePRODUCT buttons 0 through 9 to a maximumof 9:59:59.If the program does not require a time, press theflashing E button when the STATUS READOUTdisplays " ". The oven will runcontinuously at the programmed temperaturewith the STATUS READOUT displaying " ".No other buttons will be activated until the ovenhas reached the programmed temperature.Once the oven has reached the programmedtemperature the STATUS READOUT willdisplay " ", the buzzer will sound briefly andall PRODUCT buttons which are programmed atthe same temperature will also flash.To run the MANUAL PROGRAM, load theproduct to be baked.Press the MAN PROG button, the STATUSREADOUT will display " " and the shelflights will flash.