3IMPORTANT READ FIRST IMPORTANTCAUTION THE OVEN WEIGHS 500 LBS. FOR SAFE HANDLING, INSTALLERSHOULD OBTAIN HELP AS NEEDED, OR EMPLOY APPROPRIATEMATERIALS HANDLING EQUIPMENT (SUCH AS A FORKLIFT, DOLLY, ORPALLET JACK) TO REMOVE THE UNIT FROM THE SKID AND MOVE IT TOTHE PLACE OF INSTALLATION.CAUTION ANY STAND, COUNTER OR OTHER DEVICE ON WHICH THE OVEN WILLBE LOCATED MUST BE DESIGNED TO SUPPORT THE WEIGHT OF THEOVEN.CAUTION SHIPPING STRAPS ARE UNDER TENSION AND CAN SNAP BACK WHENCUT.WARNING INSTALLATION OF THE UNIT MUST BE DONE BY PERSONNEL QUALIFIEDTO WORK WITH PLUMBING. IMPROPER INSTALLATION CAN CAUSEINJURY TO PERSONNEL AND/OR DAMAGE TO EQUIPMENT. UNIT MUSTBE INSTALLED IN ACCORDANCE WITH ALL APPLICABLE CODES.NOTICE The data plate is located above control panel behind wire mesh screen.The oven serial number, gas specifications, and clearance specificationsare on the data plate. This information should be carefully read andunderstood before proceeding with the installation.NOTICE The installation of any components such as a vent hood, greaseextractors, fire extinguisher systems, must conform to their applicableNational, State and locally recognized installation standards.WARNING THIS APPLIANCE IS EQUIPPED WITH A 3-PRONG (GROUNDING) PLUGFOR YOUR PROTECTION AGAINST SHOCK HAZARD AND MUST BEPLUGGED DIRECTLY INTO A PROPERLY GROUNDED 3-PRONGRECEPTACLE. DO NOT CUT OR REMOVE THIS GROUNDING PRONGFROM THE PLUG.WARNING CONVECTION OVENS INSTALLED WITH CASTERS MUST HAVE THEFOLLOWING: A CONNECTOR THAT COMPLIES WITH THE STANDARDFOR CONNECTORS FOR MOVABLE GAS APPLIANCES ANSI Z21.69LATEST EDITION, A QUICK DISCONNECT THAT COMPLIES WITH THESTANDARD FOR QUICK DISCONNECT DEVICES FOR USE WITH GASFUEL, ANSI Z21.141 LATEST EDITION, A TETHER OR OTHER MEANS TOLIMIT APPLIANCE MOVEMENT WITH OUT RELIANCE ON THE GASSUPPLY PIPING. SECURELY ATTACH THE TETHER TO THE EYEBOLTPROVIDED AT THE REAR OF THE APPLIANCE.NOTICE Kits designed to accommodate ovens from sea level to 5000 feet. Contactfactory for orifice sizes on installations above 5000 feet.WARNING BEFORE LIGHTING, USE A SOAP AND WATER SOLUTION TO TEST ALLJOINTS FOR GAS LEAKS.NOTICE During the first few hours of operation you may notice a small amount ofsmoke coming off the oven, and a faint odor from the smoke. This isnormal for a new oven and will disappear after the first few hours of use.CAUTION ALWAYS KEEP THE AREA NEAR THE APPLIANCE FREE FROMCOMBUSTIBLE MATERIALS.