Lantronix EDS1100 Quick Start Manual

Also see for EDS1100: User guide Command reference User guide

Contents

Lantronix EDS1100 Quick Start Manual Manual pdf 9 page image

3 Target SetupLinux Software Developers Kit (SDK) Quick Start Guide 9Configuring an IP AddressBy default, the target device (MatchPort AR, XPort Pro, or EDS1100 / 2100) will attempt to obtain an IPaddress via the DHCP protocol. Type the following command at the Linux shell prompt to determine theIP address:$ ifconfig eth0The ifconfig command can also be used to set an address, but it will not persist across a reboot.To set a temporary static address, issue the following command (replace angle bracketed items withactual values):$ ifconfig eth0 To set a static address that persists across reboots:1. Use the vi text editor to edit /usr/local/etc/netcfg. (Consult a vi manual for details on using this texteditor).2. Add the following lines to the netcfg file (replace angle bracketed items with actual values)IPADDR=NETMASK=GATEWAY=3. Write the changes to the file and exit the from the vi editor.4. Issue the ‘reboot’ command to reset the target for changes to take effect.