Lantronix PremierWave Quick Start Manual

Also see for PremierWave: Quick start User guide

Contents

Lantronix PremierWave Quick Start Manual Manual pdf 6 page image

Connecting a PremierWave Device—Network MethodPremierWave Evaluation Board Quick Start 6Connecting a PremierWave Device—Network MethodChoose the desired connection method for your PremierWave, and then follow the instructions inthe corresponding section. You have three options for connecting to PremierWave:1. Wired connection via Ethernet cable.2. Wireless connection via Wireless router (Infrastructure)3. Wireless connection via Wireless card (Adhoc – factory default)Option 1: Wired connection via Ethernet1. Connect the PC to the PremierWave Evaluation Board with a cross-over cable or ahub/switch and two RJ45 cables. Make sure there is no router between the PC and theEvaluation Board.2. Select the appropriate power plug adaptor for your geographical location. Insert it into the sloton the Universal Power Supply; then plug the power supply into an outlet.3. Connect the output plug of the power supply to the PremierWave Evaluation Board.4. Move the power switch on the Evaluation Board to ON. This is the last step in 'connection.'The PremierWave is ready for configuration.5. Continue with Install DeviceInstaller on page 8Option 2: Wireless connection via Access Point or Wireless Router.1. Ensure the PC communicates with the access point (AP) or wireless router (WR) and that theAP or WR is running correctly.2. Ensure the PC is on the LAN (not the WAN) side of the AP or WR.3. Make sure there is no other router between the PC and the AP or WR.4. Change the AP or WR configuration as follows:a. Set the Network name (SSID) to the Lantronix Initial Infra Network.b. Disable all wireless security (no encryption, no/open authentication).